PANTRONCAB-TEST-4Measurement Cable

CAB-TEST-4

CAB-TEST-4 is the Pantron measurement cable used to connect a multimeter to the analog output of measuring amplifiers such as the ISG-N14M and ISG-N124M. It simplifies setup, adjustment, and service work by making the analog signal easy to read during alignment and diagnostics.

4 m length4 mm banana plugAnalog output accessISG-N14MISG-N124MService setup tool

Key Features

For connecting a multimeter to the analog output of a measuring amplifier.
Designed for use with Pantron ISG-N14M and ISG-N124M measuring amplifiers.
Uses a 4 mm banana plug for meter connection.
Standard cable length is 4 m.
Supports sensor setup and visual alignment work using the amplifier’s analog output.
Other lengths are available upon request.

Best Fit Applications

Sensor adjustment using the analog output of a Pantron measuring amplifier.
Commissioning work where a multimeter reading helps optimize alignment.
Maintenance and troubleshooting of measuring amplifier systems.
Bench testing of supported amplifiers before installation.

CAB-TEST-4 is a practical service accessory for any application where analog output readings are used to verify or fine-tune sensor alignment.

Technical Specifications

Accessory type	Measurement cable
Primary use	Multimeter connection to analog output
Compatible measuring amplifiers	ISG-N14M and ISG-N124M
Meter connection	Banana plug 4 mm

Standard cable length	4 m
Typical workflow	Sensor setup, adjustment, and verification
Other lengths	Available upon request
Order code	CAB-TEST-4

Ordering Information

Description	Details / notes	Order code
Measurement cable	Length: 4 m; for connecting a multimeter to the analog output of the measuring amplifier; other lengths available upon request	CAB-TEST-4

On mobile, this table will side-scroll when needed so the full ordering note stays visible.

Integration Notes

Use the cable during setup whenever analog output feedback is needed for precise sensor adjustment.
Confirm the amplifier model has the supported measuring-output function before use.
Keep the cable in the service kit for installations that use ISG-N14M or ISG-N124M amplifiers.
Use a compatible multimeter with 4 mm banana-plug inputs for the most direct connection.

CAB-TEST-4 is intended as a diagnostic and setup tool rather than a permanently installed process cable.

Related Workflow Use

Useful for determining the optimal visual contact between transmitter and receiver.
Helps technicians convert analog amplifier output into an immediate meter reading during setup.
Improves repeatability in maintenance procedures that rely on analog alignment verification.
Works especially well alongside Pantron measuring amplifiers designed for testing and adjustment.

This accessory is best viewed as part of a measurement and commissioning workflow built around Pantron’s measuring-amplifier products. citeturn578098search0turn578098search1